The coarser grades have lower specific surface area. Does that change how they behave?
Yes, and it is the main reason size selection matters more than series selection.
Surface area drives how much binder and oil the powder takes up, and how much light it scatters. Going from 6 µm (area 9) to 20 µm (area 2) cuts the surface area by more than four times at the same loading. In practice that means less oil demand, easier wetting, better flow — and visibly less soft-focus, because larger plates scatter less.
If a formula was built around 6 µm and you move to 20 µm to save cost, expect the texture to feel lighter and the coverage to drop. Compensate with a finer soft-focus filler rather than by increasing the boron nitride loading.
| Market | Status | Basis and conditions |
|---|---|---|
| EU | Permitted | CosIng listed; no Annex restriction — No concentration limit for cosmetic use. |
| UK | Permitted | No Annex restriction |
| US | Permitted | No ingredient-level restriction |
| China | Permitted | IECIC |
| Japan | Permitted | General cosmetic ingredient |
| ASEAN | Permitted | ACD, no Annex entry |
| Korea | Permitted | MFDS cosmetic ingredient standard |
| Canada | Permitted | Hotlist: not listed |
Swipe the table sideways for the full basis column →
Watch: None at ingredient level. The hexagonal (h-BN) and cubic (c-BN) forms are different materials; specification sheets should state which one is supplied.
Checked November 2026. Summary only — every material in the same format. Not legal advice; verify before labelling.