What loading do you recommend in pressed powder and in loose powder?
A common starting point is 3–8%, adjusted upward for skin feel. Loadings above 15% are rare.
At low loading boron nitride mainly improves spreading and slip, and contributes little to compact strength. From roughly 5% the difference in hand feel becomes noticeable. Loose powders can go to 8–10%. Beyond that you are buying smaller and smaller improvements at a rising cost, and a high proportion of platy powder makes the pressed compact more brittle, so it chips more in transit.
If you are reformulating away from talc, the loading usually lands higher — see the replacement question below.
| Market | Status | Basis and conditions |
|---|---|---|
| EU | Permitted | CosIng listed; no Annex restriction — No concentration limit for cosmetic use. |
| UK | Permitted | No Annex restriction |
| US | Permitted | No ingredient-level restriction |
| China | Permitted | IECIC |
| Japan | Permitted | General cosmetic ingredient |
| ASEAN | Permitted | ACD, no Annex entry |
| Korea | Permitted | MFDS cosmetic ingredient standard |
| Canada | Permitted | Hotlist: not listed |
Swipe the table sideways for the full basis column →
Watch: None at ingredient level. The hexagonal (h-BN) and cubic (c-BN) forms are different materials; specification sheets should state which one is supplied.
Checked November 2026. Summary only — every material in the same format. Not legal advice; verify before labelling.