You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Formulation & Process

My cream turns coarse and unstable after adding powder. What now?

Three causes, in order of how often they turn up.

First, surface treatment incompatible with the emulsifier system. Hydrophobically treated powder (SI, AS) has an oil-loving surface; if the emulsion runs hydrophilic, or the primary emulsifier's HLB does not match, the powder competes for emulsifier, the interfacial film breaks, and you get a coarse cream with water separation. Fix: switch to a more hydrophilic grade, or raise emulsifier and add a co-emulsifier. Second, addition temperature too high. Added above roughly 75 C the treatment layer can partially desorb — the result is both hydrophilic and lipophilic, the worst case for stability — and particle collision increases, so agglomerates grow. Fix: add after cooling, typically 45-55 C. Third, over-shearing or uneven shear. High shear opens agglomerates, but past the optimum it breaks droplets small and they re-coalesce coarser; tipping all the powder in and then shearing leaves local concentrations too high to open. Fix: pre-disperse the powder in a small amount of oil phase, then add in stages.

One easily missed point: moisture in the powder. Untreated powder above about 1% water carries that water into an anhydrous oil phase and disrupts the interface. Measuring moisture before addition is cheap insurance.

Order of diagnosis: droplet size distribution under the microscope first (coarsening and breaking are different failures), then pH and centrifuge stability, and only then reformulate.

Not the answer you need? Request a sample or talk to our technical team — tell us your formulation system and dosage, and we will recommend the right grade.
Become a Distributor