You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Formulation & Process

Which purity indicators matter for skin care powders?

"Purity" is not a single number in a powder raw material. Split it into four groups.

Group one, hygiene: heavy metals (lead, arsenic, mercury, cadmium) and microbiology (total aerobic count, mould and yeast, heat-tolerant coliforms, Staphylococcus aureus, Pseudomonas aeruginosa). This group is a hard gate — a failure means the lot cannot be used, so read the report every batch. Group two, physical consistency: particle size distribution (D10/D50/D90) plus batch-to-batch stability of whiteness and oil absorption. Not a safety issue, but it decides reproducibility — a formula that thickens or shifts colour when you change lots usually fails here. Write ranges into the incoming specification rather than "conforms". Group three, specific impurities: asbestos for talc (must be absent), soluble borates for boron-containing minerals, and fluoride or chloride for some minerals. This depends on the mineral; not every powder needs every test. Group four, regulatory identity: INCI name, CAS number and market access status.

A practical suggestion: put the four groups into one incoming inspection sheet and tick through it per lot. Many companies only check group one, then chase reproducibility problems that keep coming back.

One clarification: "content" is usually not a purity issue. Mineral powders are mixtures, so a stated 99% refers to the main constituent and the remaining 1% is associated mineral, not an out-of-spec impurity. Judge safety on the specific impurity tests, not on the percentage.

Not the answer you need? Request a sample or talk to our technical team — tell us your formulation system and dosage, and we will recommend the right grade.
Become a Distributor