How do I build a blended oil-absorption system?
One powder is usually not enough, because absorption has to meet three conflicting demands at once: absorb fast, hold a lot, and not collapse once loaded.
Divide the work three ways. Small pores with high surface area at 2-3% grab oil quickly and carry the first two hours of matte. Large pores with high capacity at 3-5% store oil and carry the later hours. Platelet powder at 30-40% absorbs little but provides a scaffold, so the structure does not sink into skin texture once loaded.
A workable starting point: small-pore silica 2%, large-pore silica 4%, platelet powder such as mica, boron nitride or talc at 35%. This combination usually holds an eight-hour wear test and still feels comfortable on application.
Two rules for the blend. Keep the two silica grades apart in size, small pores at 3-5 microns and large at 8-12 microns, so they do not sit in the same band and pack inefficiently. Match the platelet size to the silica: platelets above 20 microns float on the surface, below 5 microns contribute little scaffold, and 8-12 microns is the balance point.
A common mistake is pushing all three to their maxima, for example 4% small pore, 8% large pore and 50% platelet. Total powder load then becomes excessive, the finish feels heavy and dry, and absorption capacity exceeds the sebum available, so the powder starts taking oil out of the formula instead. The system should match sebum output, not maximise absorption.
One simple check on the blend: photograph the face at one, four and eight hours and read the shine curve. A gradual rise with no step change is right. Heavy shine at one hour means too little small-pore material; a sudden collapse after four hours means too little large-pore capacity or too weak a scaffold.