You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Formulation & Process

Can oil control and moisturising coexist?

Yes, but through selective absorption rather than a higher absorption dose. The conflict is that powder cannot tell sebum from the emollient oil in the formula, so it takes both, and oil control ends up removing the moisturising phase along with it: the finish dries out and the bulk thickens.

Three routes. First, hydrophobic treatment. A hydrophobic surface has more affinity for low-polarity sebum and less for polar humectants such as glycerin and polyols, which gives partial selectivity. The effect is directional rather than absolute. Second, encapsulation. Coat the high-absorption powder, for example with a silicone shell, so it stays inactive during storage, then swells and starts working once sebum reaches it. This delayed-absorption design is standard in long-wear products. Third, zone-specific formulas: high absorption on the T-zone, low or none on the cheeks. This is the simplest route, and many brands already work this way.

Structurally, keep the moisturising ingredients where the powder cannot reach them. Water-phase humectants belong in the internal phase with the powder in the external phase, which limits contact. Oil-phase emollients such as squalane and esters, if required, should stay under 3% or use types with low affinity for the powder.

A diagnostic: measure bulk viscosity and spread before and after adding powder. A clear thickening that makes application drag means the powder is absorbing the oil phase and moisturising will suffer. No change at all means it is absorbing mainly free oil or very little, and oil control will be weak. The target sits between the two.

One useful shift in thinking: choose a grade with moderate capacity and fast uptake rather than maximum capacity. Pulling surface oil away quickly is enough for a matte look, and there is no need to reach deeper oil. This balance point is the most commonly missed one in oil-control development.

Not the answer you need? Request a sample or talk to our technical team — tell us your formulation system and dosage, and we will recommend the right grade.
Become a Distributor